systems solve the problem of cooling and/or heating a space when adding ductwork
is impractical or too expensive. The matched combination of outdoor condenser
and indoor air handler fits virtually anywhere, and is simple to install and
economical to operate.
Mini-Splits are ideal for a wide range of
Homes where it’s difficult or not
desirable to use a window air conditioner, renovations and restorations,
additions, sunrooms, bedrooms, workshops, home offices
Warehouse offices, computer rooms,
Sports arena skyboxes, nursing homes,
hospitals, churches, community facilities
Installation requires a hole
less than 3" in diameter to run refrigerant lines between indoor and outdoor
units. Also, the indoor section uses low voltage wiring.
mini-split system to fit just about any installation, from single rooms to
expansive spaces. Our single, dual and tri-zone models offer an impressive array
of capacities in both A/C and heat pump models.
DMC/DMH Mini-Splits – Dual and Tri-Zone
two or three rooms (or one large space) with a single outdoor condenser
and multiple air handlers. Each of the indoor units is independently
controlled by a wireless remote for specific comfort requirements.
Dual and tri-zone units are ideal for residential use and also great
for nursing homes, classrooms, offices, churches, restaurants,
schools–anywhere individual comfort control in each room is preferred.
One of more dual or tri-zone systems can be effective (and quiet) for
settings such as church sanctuaries or fellowship halls, school commons
areas, and more.
As with all mini-splits, there is minimal disruption for installation
since ductwork is not required. The sleek indoor units blend with any
All sizes are available in cooling only and heat pump models.
Dual Zone Models: 18,000 and 24,000 BTUH system capacity; 9,000 and 12,000 BTUH per zone respectively.
Tri-Zone Models: 36,000 BTUH system capacity; 12,000 BTUH per zone.
Ideal for locations where it’s too expensive or impractical to install ductwork,
or where a window A/C can’t be used, a ductless mini-split provides the
effectiveness of a a split system without the problem of adding ducting.
Our ceiling cassettes are inconspicuous when installed. At just 9" deep,
they install easily into a ceiling while the outdoor condenser is simply
connected through a 3" hole in the wall.
The DMC Series offers quiet
operation. The split system design keeps operational sound outside, while the
indoor unit motor and fan are ultra-quiet.
Available in cooling only
models, 24,000 and 36,000 BTUH.
208-230V 60 Hz.
Inverter Technology for efficiency and comfort
Our new "V" Series mini-splits utilize inverter technology to
reduce temperature fluctuations while saving up to 40% on energy
consumption (compared to a standard mini-split).
Basically the inverter allows the compressor to run at variable
speeds to match the demand, providing precise temperature control.
Most of the time the unit runs at a low "economy" speed to
maintain the temperature and humidity levels. During times of high
demand, the compressor ramps up automatically to a higher speed.
Inverter units reach SEER levels as high as 19.1 for real energy efficiency.
All sizes are available in cooling only and heat pump models, ranging from 9,000 to 30,000 BTUH.
Mini-splits are the ideal solution for conditioning areas where
adding ductwork is impractical or too expensive. This includes older
homes, bedrooms, sunrooms, additions, office spaces, computer rooms,
sports arena skyboxes, and interior warehouse offices, to name just a
Mini-splits are easily installed with the condensing unit located
outside and the air handler(s) mounted inside. A hole less than 3" in
diameter is all that’s required to connect lines and wires between the
outdoor and indoor components. Units come pre-charged with
envionmentally friendly R-410A.
Our "S" Series of ductless mini-splits is ideal for locations where
it’s too expensive or impractical to install ductwork to add air
conditioning…or where a window air conditioning unit can’t be used.
The Indoor unit of the "S" Series includes a Temperature Compensation
feature that automatically adjusts to elminate temperature
stratification between ceiling and floor temperatures.
These cost-competitive systems are ideal for bedrooms, sunrooms,
offices, arena skyboxes, historical properties, warehouse offices and
more. A hole approximately 3-inches in diameter is all that’s needed to
connect the indoor and outdoor units.
The single zone "S" Series comes in cooling only and heat pump models, from 9,000 to 24,000 BTUH
As part of the American Recovery and Reinvestment Act of 2009, a
tax credit is available on certain ductless mini-split installations.
To learn more about mini-split equipment offered by Heat Controller, Inc., that qualifies for the tax credit Click Here.
For a copy of IRS form 5695 – Residential Energy Efficient Property Credit for tax year 2008 – Click Here.
For more information on the Tax Credit, consult the following sources:
Click Here for detailed information from Energy Star on the tax credits for energy efficiency.
Click Here to see what federal, local, and utility energy efficiency incentives are available in your area.